8C-2 INSTRUMENTATION/DRIVER INFORMATION
General Description
Combination Meter
[A]: Terminal arrangement of coupler viewed from harness side 3. Tachometer (if equipped) 7. ABS/EBD circuit (if equipped)
[B]: The upper side of combination meter 4. Fuel meter 8. Buzzer
1. Voltage regulator 5. Temp. meter 9. Connector A
2. Speedometer 6. Interface circuit
A29
A1 A2 A3 A4 A5 A6 A7 A8 A9 A10
A17 A2
A13 A1 A19 A15 A31 A20 A21 A26 A23 A25
A12 A10 A7 A24 A3 A14 A30A22A6 A4 A9 A8
A11
A12 A13 A14 A15 A16
A17 A18 A19 A20 A21 A22 A23 A24 A25 A26 A27 A28 A29 A30 A31 A32
[A]
[B]
12
6
345
7
8
A27 A11 A18 A28
9
Terminal A
A1 To ground BLK A17 To positive terminal at battery WHT/BLU
A2 To ignition switch BLK/RED A18 To tail light relay RED/YEL
A3 To ground BLK A19 To ground BRN
A4 To SDM BLU A20 To fuel level gauge YEL/RED
A5 – – A21 To ECM WHT/GRN
A6 To oil pressure switch YEL/BLK A22 To ECM (Z13DT engine) PNK
A7 To ABS control module ORN A23 To generator WHT/RED
A8 To EPS control module GRY A24 To brake fluid level switch and park-
ing brake switch
YEL/GRN
A9 To ECM (Z13DT engine) GRY/RED A25 To A/T control module (M13 engine) BLU/YEL
A10 To ABS control module BLU/BLK A26 To ECM PPL/WHT
A11 To turn and hazard switch GRN/YEL A27 To turn and hazard switch GRN/RED
A12 To ECM (Z13DT engine) GRN/YEL A28 To ignition switch YEL/BLK
A13 To dimmer switch RED A29 To positive terminal at battery WHT/BLU
A14 – – A30 To door switch BLK/ORN
A15 To speed sensor or ECM PPL A31 To ECM BRN/YEL
A16 – – A32 – –
To Next Page
Loading...
