ELECTRICAL POWER STEERING (EPS) SYSTEM (IF EQUIPPED) 3B1-3
Diagnosis
“EPS” Warning Lamp Circuit Check Flow Table for M13 Engine Model
CAUTION:
Be sure to perform “System Check Flow Table” before starting diagnosis according to flow table.
Step Action Yes No
1 1) Make sure that battery voltage is about 11 V
or higher.
2) Note “EPS” warning lamp as ignition switch
is turned to ON position.
Does “EPS” warning lamp come ON when igni-
tion switch is turned to ON position?
Go to Step 2. Proceed to “Ta bl e - A
“EPS” Warning Lamp
Does Not Light”.
2Check that “EPS” warning lamp lights for 2 sec.
and then goes OFF.
“EPS” warning lamp is in
good condition.
Check for any DTC refer-
ring to “Diagnostic Trouble
Code (DTC) Check” in
Section 6-1 for G10
engine model or in Sec-
tion 6-2 for M13 engine
model. If there is any,
troubleshoot the prob-
lem(s). If not, proceed to
“Tab l e- B “EPS” Warning
Lamp Remains ON”.
To Next Page