6-2-138 ENGINE GENERAL INFORMATION AND DIAGNOSIS (M13 ENGINE)
DTC P0107 Manifold Absolute Pressure Low Input
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Drive the vehicle with the speed of 40 km/h (25 mile/h) in the 5th gear or D range, and then accelerate the
vehicle for more than 5 seconds by stepping only half of the accelerator pedal.
4) Check DTC and pending DTC.
1. Manifold absolute pressure sensor 2. To TP sensor 3. To other sensors 4. ECM
E23 E22 E21
12345671234561234567
7
891011121314151617 8910111213141516 891011121314151617
1819
1819
1718192021222324252627 20212223 202122232425 24252627 2627
2829303132 32 282930 28293031 3133 33 323334 3435 3435
WHT/GRN WHT/GRN
LT GRN/RED
E22-28
E22-15
E22-8
4
2
1
3
BRN/WHT BRN/WHT
E23-2
BLK/YEL
BLK/YEL
E23-1
DTC Detecting Condition Trouble Area
• Manifold absolute pressure sensor output voltage is
lower than specified value for specified time continu-
ously.
(1 driving cycle detection logic)
• Manifold absolute pressure sensor circuit
• Manifold absolute pressure sensor
• Manifold absolute pressure sensor vacuum
passage
• ECM
WARNING:
• When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out with 2 persons, a driver and a tester, on a level road.
To Next Page
Loading...
