GENERAL INFORMATION 0A-21
Vehicle Lifting Points
When using frame contact hoist
WARNING:
• Before applying hoist to underbody, always take vehicle balance throughout service into consider-
ation. Vehicle balance on hoist may change depending on what part to be removed.
• Before lifting up the vehicle, check to be sure that end of hoist arm is not in contact with brake pipe,
fuel pipe, bracket or any other part.
• When using frame contact hoist, apply hoist as shown (right and left at the same position). Lift up
the vehicle till 4 tires are a little off the ground and make sure that the vehicle will not fall off by try-
ing to move vehicle body in both ways. Work can be started only after this confirmation.
• Make absolutely sure to lock hoist after vehicle is hoisted up.
1. Front left tire 4. Support position for frame contact hoist and safety stand
2. Rear left tire 5. Floor jack position
3. Vehicle front
To Next Page
Loading...
