7B1-70 AUTOMATIC TRANSAXLE (M13 ENGINE)
DTC P0962 Pressure Control Solenoid Control Circuit Low
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF, if available.
2) Clear DTC in TCM memory.
3) Start engine.
4) Keep engine running at idle speed for 30 seconds or more.
5) Stop vehicle and check DTC.
DTC Troubleshooting
1. TCM 3. A/T
2. Pressure control solenoid valve [A]: Terminal arrangement of TCM connector (Viewed from harness side)
DTC DETECTING CONDITION TROUBLE AREA
Pressure control solenoid valve output voltage is too low
comparing with TCM command value.
• Pressure control solenoid valve circuit open or
shorted to ground.
• Malfunction of pressure control solenoid valve
• TCM
12V
E13-4
E13-2
BRN/YEL
LT GRN/RED
3
1
2
4
2
E13
E12
[A]
Step Action Yes No
1Was “Automatic Transaxle Diagnostic Flow Table”
performed?
Go to Step 2. Go to “Automatic Tran-
saxle Diagnostic Flow
Tabl e ” in this section.
To Next Page
Loading...
