AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-183
12) Install 1st and reverse brake plate snap ring so that its both
ends would be positioned in correct locations as shown in
figure.
13) Using special tools, measure 1st and reverse brake piston
stroke when compressed air (400 – 800 kPa, 4 – 8 kg/cm
2
,
57 – 113 psi) is brown through oil hole.
Special tool
(A) 09900-20607
(B) 09900-20701
(C) 09952-06020
1st and reverse brake piston stroke
Standard: 0.791 – 1.489 mm (0.0311 – 0.0586 in.)
14) Install reduction drive gear (1) to transaxle case (3) by using
special tools and hydraulic press.
Special tool
(A): 09951-18210
(B): 09944-78210
[A] Correct
[B] Incorrect
CAUTION:
• Do not use transaxle case as groundwork to press fit
reduction drive gear.
• Do not give load more than 20 kN (2,000 kg, 4410 lb)
with hydraulic press. Otherwise, it may result in dam-
aging reduction drive gear bearing.
2. Stand that can slightly lift transaxle case.
NOTE:
When replacing reduction drive gear, replace it together
with reduction driven gear as a set.
To Next Page
Loading...
