Suzuki Wagon R Plus RB310 - Suspension Control Arm; Bushing

3D-12 FRONT SUSPENSION
6) Install brake disc.
7) Tighten brake disc screws.
Tightening torque
Brake disc screw (a): 9 Nm (0.9
kg-m, 6.5 lb-ft)
8) Install brake caliper/caliper carrier.
9) Tighten caliper carrier bolts to specified torque.
Tightening torque
Brake caliper carrier bolt (b): 95 N
·
m (9.5 kg-m, 69.0 lb-ft)
10) Depress foot brake pedal and hold it there.
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (c): 175 N
·
m (17.5 kg-m, 127.0 lb-ft)
11) Calk drive shaft nut as shown.
12) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt: 95 N
·
m (9.5 kg-m, 69.0 lb-ft)
Suspension Control Arm / Bushing
Removal
1) Hoist vehicle and remove wheel referring to “Wheel
Removal” in Section 3F.
2) Remove split pin (12), stabilizer bar nut (10), washer (9) and
bushing (8).
3) Remove stabilizer bar mount bracket (right & left) bolts (5).
4) Remove ball stud bolt (2).
5) Remove suspension Control arm mounting bolt (6) and
washer.
6) Remove suspension control arm (7).
CAUTION:
Be careful while caulking nut so that no crack will occur
in caulked part of nut. Cracked nut must be replaced with
new one.
1. Stabilizer bar 8. Stabilizer bar bushing
2. Control arm ball stud bolt 9. Washer
3. Knuckle 10. Stabilizer bar nut
4. Ball stud 11. Suspension control arm bushing:
Before installing, apply soap water.
5. Stabilizer bar bracket bolt 12. Split pin
6. Control arm mounting bolt Tightening torque
7. Suspension control arm Do not reuse.