6E2-26 ENGINE AND EMISSION CONTROL SYSTEM (M13 ENGINE)
Fuel injector inspection
1) Install injector to special tool (injector checking tool).
Special tool
(A): 09912-58421
(B): 09912-57610
2) Connect special tools (hose and attachment) to fuel feed
pipe (1) of vehicle.
3) Connect special tool (test lead) to injector.
Special tool
(C): 09930-88530
4) Install suitable vinyl tube onto injector nozzle to prevent fuel
from splashing out when injecting.
5) Put graduated cylinder under injector.
WARNING:
As fuel is injected in this inspection, perform in a well
ventilated area and away from open flames.
Use special care to prevent sparking when connecting
and disconnecting test lead to and from battery.
To Next Page
Loading...
