ENGINE GENERAL INFORMATION AND DIAGNOSIS (M13 ENGINE) 6-2-33
Scan Tool Data Definitions
COOLANT TEMP (ENGINE COOLANT TEMPERATURE, °C, °F)
It is detected by engine coolant temp. sensor.
INTAKE AIR TEMP. (°C, °F)
It is detected by intake air temp. sensor.
ENGINE SPEED (rpm)
It is computed by reference pulses from the camshaft position sensor.
TOTAL FUEL TRIM B1 (%)
The value of Total Fuel Trim is obtained by calculating based on values of short Term Fuel Trim and Long Term
Fuel Trim. This value indicates how much correction is necessary to keep the air/fuel mixture stoichiometrical.
INJ PULSE WIDTH (FUEL INJECTION PULSE WIDTH, msec.)
This parameter indicates time of the injector drive (valve opening) pulse which is output from ECM (but injector
drive time of NO.1 cylinder for multiport fuel injection).
TP SENSOR VOLT (THROTTLE POSITION SENSOR OUTPUT VOLTAGE, V)
The Throttle Position Sensor reading provides throttle valve opening information in the form of voltage.
DESIRED IDLE (DESIRED IDLE SPEED, rpm)
The Desired Idle Speed is an ECM internal parameter which indicates the ECM requested idle. If the engine is
not running, this number is not valid.
IAC FLOW DUTY (IDLE AIR (SPEED) CONTROL DUTY, %)
This parameter indicates current flow time rate within a certain set cycle of IAC valve (valve opening rate) which
controls the amount of bypass air (idle speed).
SHORT FT B1 (SHORT TERM FUEL TRIM, %)
Short term fuel trim value represents short term corrections to the air/fuel mixture computation. A value of 0 indi-
cates no correction, a value greater than 0 means an enrichment correction, and a value less than 0 implies an
enleanment correction.
RADIATOR FAN
(RADIATOR FAN CON-
TROL RELAY)
Ignition switch ON Engine coolant temp.:
Lower than 92.5°C
(198.5°F)
OFF
Engine coolant temp.:
97.5°C (208°F) or higher
ON
BLOWER FAN Ignition switch ON Blower fan switch: 2nd
speed position or more
ON
Blower fan switch: under
2nd speed position
OFF
A/C SWITCH
(if equipped with A/C)
Engine running after warming up, A/C not oper-
ating
OFF
Engine running after warming up, A/C operat-
ing
ON
A/C MAG CLUTCH
(if equipped with A/C)
Engine running A/C switch and blower
motor switch turned ON
ON
A/C switch and blower
motor switch turned OFF
OFF
VEHICLE SPEED At stop 0 km/h
SCAN TOOL DATA VEHICLE CONDITION NORMAL CONDITION/
REFERENCE VALUES
To Next Page
Loading...
