EasyManua.ls Logo

Suzuki Wagon R Plus RB310 - Rear Suspension

Suzuki Wagon R Plus RB310
846 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REAR SUSPENSION 3E-1
3E
3F
4
4B
5
5A
5B
5C
6-2
6A2
6B2
SECTION 3E
REAR SUSPENSION
CONTENTS
General Description........................................3E-2
Diagnosis.........................................................3E-4
Wheel Disc, Bolt and Bearing Check ............3E-4
On-Vehicle Service..........................................3E-5
Lateral Rod....................................................3E-7
Coil Spring.....................................................3E-8
Bump Stopper ...............................................3E-9
Trailing Arm...................................................3E-9
Rear Axle (for 2WD Model)......................... 3E-11
Wheel Bearing (for 2WD Model) ................. 3E-13
Rear Axle Shaft and Wheel Bearing (for 4WD
Model) ......................................................... 3E-15
Rear Axle Housing (for 4WD Model)........... 3E-19
Tightening Torque Specifications............... 3E-24
Required Service Material............................ 3E-25
Special Tool................................................... 3E-26
WARNING:
Do not removal all of the wheel bolts at once, because all the wheels of this vehicle are mounted by
the wheel bolts.
Leave a bolt at least not to drop the wheel.
Support the wheel and/or tire and then remove the bolt(s) left with the wheel.
NOTE:
All suspension fasteners are an important attaching part in that it could affect the performance of
vital parts and systems, and/or could result in major repair expense. They must be replaced with
one of the same part number or with an equivalent part if replacement becomes necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as speci-
fied during reassembly to assure proper retention of this part.
Never attempt to heat, quench or straighten any suspension part. Replace it with a new part, or damage
to the part may result.
For descriptions (items) not found in this section, refer to the same section of the Service Manual
mentioned in FOREWORD of this manual.

Table of Contents

Related product manuals