7A2-28 MANUAL TRANSAXLE (M13 ENGINE)
14) Clean mating surface of guide case.
15) Install fifth gear referring to “Fifth Gear Disassembly and
Assembly” in this section.
16) Install gear shift and select shaft assembly referring to “Gear
Shift and Select Shaft Assembly Removal and Installation” in
this section.
17) Tighten back up lamp switch (1) to specified torque.
Tightening torque
Back up lamp switch (b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
18) Check input shaft for rotation in each gear position.
19) Also confirm continuity of back up lamp switch in reverse
position using ohmmeter.
Transaxle Case Disassembly and Assembly
Disassembly
1) Remove input shaft oil seal (1) using special tools, if neces-
sary.
Special tool
(A): 09930-30104
(B): 09923-74510
2) If input shaft right bearing has been left in right case, pull it
out using special tools.
Special tool
(A): 09930-30104
(B): 09923-74510
3) Also pull out countershaft right bearing cup (2) using special
tools, if necessary.
Special tool
09941-64511
09930-30104
4) Remove counter shaft left bearing cup from left case using
special tools.
Special tool
09913-84510
5) Replace differential side oil seal(s) referring to “Differential
Side Oil Seal Replacement” in this section, if necessary.
6) Remove oil gutter from left case, if necessary.
To Next Page
Loading...
