6A2-26 ENGINE MECHANICAL (M13 ENGINE)
Oil Pan and Oil Pump Strainer Components
Oil Pan and Oil Pump Strainer Removal and
Installation
Removal
1) Remove oil level gauge.
2) Drain engine oil by removing drain plug.
3) Remove exhaust No.1 pipe (1), exhaust manifold stiffener (2)
and clutch housing lower plate (3).
4) For 2WD vehicle, remove engine rear mounting bracket.
5) For 4WD vehicle, remove transfer referring to “Transfer Dis-
mounting and Mounting” in Section 7D.
[A]: Sealant application amount 3. O-ring 8. Oil pan bolt and nut
“a”: 3 mm (0.12 in.) 4. Gasket Tightening torque
“b”: 2 mm (0.08 in.) 5. Oil pan drain plug bolt Do not reuse.
1. Oil pan
: Apply sealant 99000-31250 to mating surface.
6. Oil pump strainer bolt
2. Strainer 7. Oil pump strainer bracket bolt
2
3
2
1
To Next Page
Loading...
