Suzuki Wagon R Plus RB310 - Page 364

ENGINE MECHANICAL (M13 ENGINE) 6A2-25
Installation
1) Install new gasket to cylinder head.
Then install exhaust manifold.
Tighten manifold bolts (1) and nuts (2) to specified torque.
Tightening torque
Exhaust manifold bolt and nut
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
2) Install new seal ring and connect exhaust No.1 pipe (1) to
exhaust manifold.
Tighten pipe fasteners to specified torque.
Tightening torque
Exhaust No.1 pipe bolt (a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
3) Install exhaust manifold stiffener (2).
Tighten exhaust manifold stiffener bolts to specified torque.
Tightening torque
Exhaust manifold stiffener bolt
(b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
4) Install new seal ring and connect exhaust No.1 pipe (1) to
exhaust No.2 pipe.
Tighten pipe fasteners to specified torque.
Tightening torque
Exhaust No.2 pipe bolt (c): 43 N·m (4.3 kg-m, 31.5 lb-ft)
5) Connect heated oxygen sensor coupler (1) and fit coupler to
bracket securely.
6) Install A/C condenser to vehicle body for equipped with A/C.
7) Install radiator referring to “Radiator Removal and Installa-
tion” in Section 6B2 for equipped with A/C.
8) Install front bumper with front grille by referring to “Front
Bumper and Rear Bumper” in Section 9.
9) Connect negative cable to battery.
10) Check exhaust system for exhaust gas leakage.
NOTE:
The figure on the left varies with specification.
2,(a) 1,(a)
2
2
1
(a) (b)
(c)
1