MAINTENANCE AND LUBRICATION 0B-19
Automatic Transmission Fluid Replacement
1) Inspect transmission case for evidence of fluid leakage.
Repair leaky point, if any.
2) Make sure that vehicle is placed level for fluid level check.
3) Change fluid. For its procedure, refer to “Fluid Change” in
Section 7B.
Automatic Transmission Fluid Cooler Hose
Inspection
Check automatic transaxle fluid cooler hose for fluid leakage,
cracks, damage and deterioration.
Replace hose and/or clamp if any faulty condition is found.
Transfer Oil (4WD) and Rear Differential Oil
(4WD) Inspection
1) Check transfer case or differential for evidence of oil leakage.
Repair leaky point if any.
2) Make sure that vehicle is placed level for oil level check.
3) Remove level plug of transfer or differential and check oil
level.
Oil level can be checked roughly by means of level plug hole.
That is, if oil flows out of level plug hole or if oil level is found
up to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified amount of specified
oil referring to “Transfer Oil Change” in Section 7D or “Rear
Differential Oil Change” in Section 7F.
4) Tighten level plug to specified torque referring to “Tra n sf er
Oil Change” in Section 7D or “Rear Differential Oil Change”
in Section 7F.
1. Drain plug
[A]: Transfer
[B]: Rear differential
1. Oil level/filler plug
2. Drain plug
To Next Page
Loading...
