FRONT SUSPENSION 3D-13
7) Remove bushing.
Place suspension control arm onto flat surface side of spe-
cial tool and push out bushing with special tool and oil
hydraulic press as shown.
Special tool
(A): 09943-77910
Installation
1) Place suspension control arm onto flat surface side of spe-
cial tool and install new bushing with special tool and oil
hydraulic press as shown.
Special tool
(A): 09943-77910
2) Install suspension control arm to vehicle body and tighten
suspension Control arm mounting bolt (1) and washer tem-
porarily.
NOTE:
• Before installing bushing, apply soap water on its cir-
cumference to facilitate installation.
• When installed, bush should be equal on the right and
left of arm as shown.
To Next Page
Loading...
