3E-14 REAR SUSPENSION
2) Remove circlip (1).
Special tool
(A): 09900-06108
3) Remove wheel bearing by using special tool and hydraulic
press.
Special tool
(A): 09913-76010
Installation
1) Install new wheel bearing (1) by using special tool and
hydraulic press.
Special tool
(A): 09913-75810
2) Install circlip (1).
Special tool
(A): 09900-06108
3) Install brake drum and wheel, referring to “Brake Drum”
Installation in Section 5C.
CAUTION:
• Never reuse wheel bearing.
• Reused bearing should have excessive play.
NOTE:
Seal side of bearing comes brake back plate side.
To Next Page
Loading...
