4A-12 FRONT DRIVE SHAFT (G10/M13 ENGINES)
10) Install damper (1) on left side drive shaft according to dimen-
sion specified below.
Damper installation position
For M/T model with M13 engine
“a”: 134 – 140 mm (5.28 – 5.51 in.)
For A/T model with M13 engine
“a”: 157 – 163 mm (6.18 – 6.42 in.)
11) Install retaining ring (2) to cage (1).
12) Set new differential side small band (2) and differential side
boot (1) on shaft temporarily.
13) Apply grease in the supplied parts to DOJ and inside of
housing.
Grease color: Black
Grease amount: Approx. 60 g (2.1 oz)
14) Place DOJ onto spline of drive shaft and drive onto drive
shaft by using plastic hammer until retaining ring engages.
To Next Page
Loading...
