6A2-14 ENGINE MECHANICAL (M13 ENGINE)
b) Check housing No. and select special tool corresponding to
housing No. referring to the following table.
Special tool selection table
c) Hold down the tappet so as not to contact the shim by
installing special tool on camshaft housing with housing bolt
(1) tighten housing bolts to specified torque.
Special tool
(A): 09916-67020 or 09916-67021
Tightening torque
Camshaft housing bolt (for tightening of special tool)
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
4) Turn camshaft by approximately 90° clockwise and remove
shim (3).
No. on camshaft
housing
Embossed mark
on special tool
I2 IN2
I3, I4, I5 IN345
E2 EX2
E3, E4, E5 EX345
A: I: Intake side or E: Exhaust side
B: Position from timing chain side
C: Pointing to timing chain side
WARNING:
Never put in the hand between cam shaft and tappet.
1. Special tool
2. Magnet
To Next Page
Loading...
