6A2-38 ENGINE MECHANICAL (M13 ENGINE)
11) Install water pump pulley.
12) Install cylinder head cover referring to “Cylinder Head Cover
Removal and Installation” in this section.
13) Install oil pan referring to “Oil Pan and Oil Pump Strainer
Removal and Installation” in this section.
14) Install crankshaft pulley (1). Tighten bolt (2) to specified
torque. To lock crankshaft pulley, use special tool with it as
shown in the figure.
Special tool
(A): 09917-68221
Tightening torque
Crankshaft pulley bolt (a): 150 N·m (15.0 kg-m, 108.5 lb-ft)
15) Install engine assembly to vehicle referring to “Engine
Assembly Removal and Installation” in this section.
Timing Chain Cover Inspection
Oil seal
• Check oil seal (1) lip for fault or other damage.
Replace as necessary.
Special tool
(A): 09913-75810
Drive in dimension
“a”: 1.5 mm (0.06 in.)
Timing chain cover
Inspect strainer (1) of oil passage for driving intake cam timing
sprocket assembly (VVT actuator).
If clog or foreign matter exists, clean strainer.
NOTE:
When installing new oil seal, press fit to timing chain
cover (2) by using special tool (Bearing installer) as
shown in the figure.
“a”
1
To Next Page
Loading...
