Suzuki Wagon R Plus RB310 - Page 642

AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-73
Fig. for Step 3.
3 Check pressure control solenoid valve resistance
1) Turn ignition switch OFF
2) Disconnect valve body harness connector on
automatic transmission.
3) Check for proper connection to solenoid at
“BRN/YEL” and “LT GRN/RED” circuit.
4) Check resistance of pressure control solenoid.
See Fig.
Resistance between pressure control solenoid
valve terminals of transmission side valve body
harness connector:
5.0 – 5.6
Ω
(at 20°C (68°F))
Resistance between pressure control solenoid
valve terminals of transmission side valve body
harness connector and transmission body:
Infinity
Is check results satisfactory?
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
“Intermittent and Poor
Connection” in Sec-
tion 0A. If OK, substi-
tute a known-good
TCM and recheck.
Replace pressure control
solenoid valve or valve
body harness.
Step Action Yes No
1. Valve body harness connector on harness
2. Valve body harness connector on transaxle
3. Ground (transaxle)
1
6
7
89
10
5
43
2
1
2
3