Suzuki Wagon R Plus RB310 - Page 665

7B1-96 AUTOMATIC TRANSAXLE (M13 ENGINE)
Adjustment
1) Shift manual shift lever to “N” range (transmission range sen-
sor “N” range).
2) Remove adjuster (cable end) from selector lever pin of selec-
tor lever assembly.
3) Release lock plate (1) which restrict moving of cable end
holder (2).
4) Push cable end holder (1) out from eye-end (2) using an
appropriate tool (3) to disengage cable.
5) Shift selector lever to “N” position.
6) Apply grease to selector lever pin and install adjuster (cable
end) to it.
Grease 99000-25010
7) With both selector lever and transmission range sensor kept
each “N” position, drive cable end holder (1) in until it locks
cable.
8) Slide lock plate (2) to secure cable end holder in position.
9) After select cable was installed, check for the following.
• Push vehicle with selector lever shifted to “P” range.
Vehicle should not move.
• Vehicle can not be driven in “N” range.
• Vehicle can be driven in “D”, “2” and “L” ranges.
• Vehicle can be backed in “R” range.
“P”
“R”
“N”
“D”
“2”
“L”