7B1-116 AUTOMATIC TRANSAXLE (M13 ENGINE)
Dismounting
1) Take down transaxle with engine. For its procedure, refer to
“Engine Assembly” in Section 6A2.
2) Remove lower stiffener (1).
3) Remove drive plate to torque converter bolts.
To lock drive plate (1), engage flat head rod or the like (2)
with drive plate ring gear.
4) Remove starting motor.
5) Remove bolts and nut fastening engine and transaxle, then
detach transaxle from engine.
1
WARNING:
Be sure to keep transaxle with torque converter horizon-
tal or facing up throughout the work. Should it be tilted
with torque converter down, converter may fall off and
cause personal injury.
NOTE:
When detaching transaxle from engine, move it in paral-
lel with crankshaft and use care so as not to apply exces-
sive force to drive plate and torque converter.
To Next Page
Loading...
