AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-129
27) Remove input shaft front thrust bearing (1).
28) Remove input shaft rear thrust bearing (1) and thrust bearing
race (2).
29) Remove direct clutch hub (1).
30) Remove differential assembly (1) and counter shaft assem-
bly (2).
31) Remove governor apply No.2 gasket (1).
NOTE:
If input shaft front thrust bearing is not found, it may
have been taken out with oil pump assembly.
NOTE:
If input shaft rear thrust bearing is not found, it may have
been taken out with direct clutch assembly.
To Next Page
Loading...
