7B1-156 AUTOMATIC TRANSAXLE (M13 ENGINE)
• Do not damage forward clutch return spring subassembly
and balancer by pressing in forward clutch return spring sub-
assembly passing through its original installing position over
1.5 mm (0.059 in.).
Special tool
(A): 09926-97610
• Apply A/T fluid to forward clutch separator plates (1), discs
(2) and retaining plate (3).
• Install forward clutch separator plates (1), discs (2) and
retaining plate (3), then snap ring (4) to forward clutch drum.
• Install forward clutch plate snap ring so that its both ends
would be positioned in correct locations as shown in figure.
[A] Correct
[B] Incorrect
To Next Page
Loading...
