7F-6 REAR DIFFERENTIAL
DISASSEMBLY
1) Put match marks (4) on differential side bearing caps (3) and
differential carrier (1).
2) Take off differential side bearing caps by removing their bolts
and remove differential gear assembly (2) with shims.
3) With aluminum plates placed on vise first, grip differential
case with it and remove drive bevel gear by removing its
bolts.
4) Using special tools, pull out differential side bearings.
Special tool
(A): 09913-60910
(B): 09925-88210
5) Drive out differential pinion shaft pin with special tool.
Special tool
(A): 09922-85811
6) Remove differential pinion shaft.
7) Remove differential side gears, pinions and washers.
8) Uncaulk drive bevel pinion nut.
NOTE:
Check number of shims and thickness of each shim in
advance.
1. Differential case
2. Differential side gear
3. Differential pinion shaft
To Next Page
Loading...
