3E-6 REAR SUSPENSION
4WD model
“A”: Body outside 11. Oil seal 22. Brake back plate bolt
1. Rear coil spring 12. Spacer:
The tapered side of spacer inner diameter
directed toward outside (brake drum side).
23. Bearing retainer ring (without ABS)
2. Rear bump stopper:
Apply soap water, when installing.
13. Oil seal protector 24. Bearing retainer ring (with ABS)
3. Rear spring upper seat 14. LSPV bracket (only vehicle with LSPV) 25. Lateral rod dumper
4. Rear shock absorber 15. Brake back plate 26. Lateral rod dumper nut
5. Lateral rod 16. Lateral rod axle housing side nut 27. Lateral rod dumper
6. Trailing arm 17. Lateral rod body side bolt:
Insert from the direction as shown.
28. Lateral rod dumper bolt
7. Rear axle shaft 18. Shock absorber upper bolt:
Insert from vehicle outside.
Tightening torque
8. Rear axle housing:
Apply water tight sealant 99000-31090 to
joint of plate and axle housing.
19. Shock absorber lower bolt Do not reuse.
9. Bearing 20. Trailing arm front bolt:
Insert from vehicle inside.
10. Brake drum 21. Trailing arm rear bolt:
Insert from vehicle inside.
26
25
27
28
5
"A"
To Next Page
Loading...
