20
Peltier Thermostatted Single Cell Holder
Thermo Scientific Evolution 200 Series User Guide 327
2. Use the down and up arrow buttons to change the set temperature.
3. When the desired set temperature is displayed, press Change to return to the Startup
page.
Y Setting the stirring speed
1. Highlight Stirring Speed.
2. The Change Set Point page is displayed with down and up arrows above the Left and
Center buttons.
3. Use the down and up arrow buttons to change the stirring speed.
4. When the desired stirring speed is reached, press Change to return to the Startup page.
Parameters Menu
•Use the Left and Center buttons to scroll the screen up and down.
•Use the Right button to exit the screen and return to the Main Menu.
Configure Menu
Diagnostic Menu
•Use the Left and Center buttons to scroll the screen up and down.
•Use the Right button to exit the screen and return to the Main Menu.
Table 6. User parameters and button functions
Number Description Default value
P-01 Temperature units °C
P-02 Auto start NO
P-03 Display contrast 5
P-04 Beeper YES
P-05 Manual reset pre-alarm NO
Note A password is required to enter this menu.
NOTICE The Configure menu parameters are set at the factory and cannot be changed
by the user.
Description Measure unit
Cell temperature °C
Radiator temperature °C
To Next Page
Loading...
