26
SPE-8W Smart Peltier Linear Cell Changer
386 Evolution 200 Series User Guide Thermo Scientific
Standby Mode
•Press and hold the Center button for one to two seconds to proceed to Normal Mode.
Normal Mode
Button Functions
•Press the Left button to go to the Main Menu page.
•Press the Right button to go to the Change Set Point page.
•Press and hold the Center button for one to two seconds to return to Stand-By Mode.
• From the Startup page in Normal Mode, use the Change button to move about the
screen.
Actual block
temperature
Stirring
speed
Heating/cooling
power scale
Block set temperature
Table 7. Startup modes and button functions
Page Mode Display Left button Center button Right button
Startup Standby Standby On
Normal Actual block temperature
Block Set temperature
Stirring speed (left)
Heating/cooling power (right)
Menu
(Go to Main
Menu)
Off Change (Go to
Change Set Point
Page)
Alarm Alarm description Menu Beep on/off Reset alarm/change*
*Only if the manual alarm reset option has been configured
To Next Page
Loading...
