33
INSIGHT Security Software
Access Control and System Policies
460 Evolution 200 Series User Guide Thermo Scientific
After specifying access control and setting the policies, save the settings in the security
database. See “Saving your security policy settings” in the “Using Security Administration”
chapter of the Security Administration User’s Guide for details.
Feature Description
Ability to tun INSIGHT Specifies which users can run INSIGHT software. (See
“Controlling access to client application features” in the
“Using Security Administration” chapter of the Security
Administration User’s Guide for general instructions.) If a user
has not been granted the ability to run the software, an error
message appears when the user attempts to start it.
Ability to delete workbooks Specifies which users can delete workbook files with the
Delete button in My Data.
Ability to delete PV reports Specifies which users can delete Performance Verification
reports with the Delete button in My Data.
Ability to delete templates Specifies which users can delete template files with the Delete
button in My Data.
Ability to delete Scan
samples
Specifies which users can delete Scan sample data files from
the current workbook by right-clicking a sample in the results
table in Measure Scan and choosing Remove.
Ability to edit templates Specifies which users can set parameters in Settings.
Ability to configure reports Specifies which users can change settings in Reports.
Ability to perform PV tests Specifies which users can run Performance Verification tests.
Ability to perform
wavelength calibration
Specifies which users can use the Wavelength Calibration
buttons on the Calibrations tab in System Settings.
Ability to calibrate Sipper Specifies which users can use the Sipper Calibrate button on
the Calibrations tab in System Settings.
Ability to calibrate Linear
Cell Changer
Specifies which users can use the Linear Cell Changer
Calibrate button on the Calibrations tab in System Settings.
Ability to update CVC
calibration
Specifies which users can use the Load CVC Calibration
button in Performance Verification.
Ability to select CVC tests
to perform in PV
Specifies which users can select listed tests for the CVC in
Performance Verification.
Math menu Specifies which users can use the commands in the Math
menu.
Analyze menu Specifies which users can use the commands in the Analyze
menu.
Ability to set Rate
parameters
Specifies which users can set parameters in Settings for the
Rate application.
To Next Page
Loading...
