09/2007
4-29
Phaser 8860/8860MFP Service Manual
REP 2.0.8
Repairs and Adjustments
Initial Issue
8. Lower the Wiper Assembly completely by rotating the drive gear s as shown.
Figure 2 Lowering the Printhead Wiper Blade
9. Hold the Printhead away from the Drum and push down on the left and right Printhead
Restraint Arms to release the Printhead Tilt Spring tension.
Figure 3 Releasing the Printhead Tilt Spring.
10. Pull the X-Axis Bias Spring and Hook out slightly, and then rotate downward to allow it to
rest in detents provided on the frame. See Figure 4.
To Next Page
Loading...
