09/2007
4-74
Phaser 8860/8860MFP Service Manual
REP 6.0.7, REP 6.0.8
Initial Issue
Repairs and Adjustments
Figure 1 Removing the Paper Size Switch
8. Pull the harness through the opening in the chassis and remove the switch from the tray
cavity.
REP 6.0.8 No Paper Sensor
Parts List on PL 6.0
Removal
1. Remove the Front Door (REP 1.0.1).
2. Remove Tray 2.
3. Remove the Pick Roller Assembly (REP 3.0.18).
4. Remove the Lower Duplex Guide (REP 3.0.2).
5. Remove the Inner Simplex Guide (REP 3.0.1).
6. Release the 4 hooks that secure the No Paper Sensor to the left side of the Pick Assem-
bly recess.
Figure 1 Removing the No Paper Sensor
7. Disconnect the sensor (P/J171) from the harness and remove the sensor.
Replacement
Disconnect the Preheater Assembly (P/J0720 and P/J860) to make additional room to replace
the sensor. Release the lock on P/J0720 to remove it from the Preheater Assembly.
To Next Page
Loading...
