09/2007
4-78
Phaser 8860/8860MFP Service Manual
ADJ 2.2.1
Initial Issue
Repairs and Adjustments
ADJ 2.2.1 Printhead Parking
Purpose
To place the Printhead in a parked position, away from the Drum, during service procedures or
when the Control Panel parking routine is unavailable.
CAUTION
After servicing the system, place the Printhead, Head Tilt Gear, Printhead Wiper Blade, and
Process Drive in their home positions before turning the system power on. Damage to the Pro-
cess Drive or system errors can result during system initialization.
Adjustment
Use this procedure to move the Printhead to its parked position.
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7 or REP 1.1.9 on the 8860).
4. Remove the Right Side Cover (REP 1.0.21 or REP 1.1.10 on the 8860).
5. Remove the Ink Loader (REP 2.0.1 or REP 1.1.8 on the 8860).
6. Engage the Head Tilt Gear as shown in Figure 1.
Figure 1 Printhead Wiper Blade Drive
7. Rotate the Drum Maintenance Camshaft until the Printhead has moved to the parked
position, which is the furthest point from the Drum.
To Next Page
Loading...
Need help?
General
