Yamaha F75F - Installing the Wire Harness

Wire harness
7-21
Installing the wire harness
1. Install:
• Clamp (to the holder)
• Holder
• Holder bolt
• Holder (to the ignition coil bracket)
• Grommet (to the ignition
coil bracket)
• Collar (to the ignition coil bracket)
• Ignition coil
bracket
• Ignition coil
bracket bolt
• Wire harne
ss (to the PTT relay bracket)
• Holder (to the PTT
relay bracket)
• Pla
stic tie (to the PTT relay bracket)
• Holder (to the PTT
relay bracket)
• Grommet (to the PTT
relay bracket)
• Collar (to the PTT relay bracket)
• PTT relay bracket
• PTT relay bracket bolt
• Ground bolt
• Oil pressure switch lead bolt
2. Install:
• PTT relay
• PTT relay bolt
• PTT relay lead nut
3. Install:
• Clam
p
• Wire harne
ss coupler
See “Electrical component and wire har-
ness routing” (5-1).
Oil pressure switch lead bolt
2.0 N·m (0.20 kgf·m, 1.5 lb·ft)
PTT relay lead nut
4.5 N·m (0.45 kgf·m, 3.3 lb·ft)
T
R
.
.
T
R
.
.