Yamaha F75F - Uncrating; Uncrating Procedure

Uncrating
3-3
Uncrating
Uncrating procedure
Wear gloves to avoid injury from sharp
steel edges while uncrating.
1. Uncrate:
• Outboard motor
a. Check the crate for shipping damage.
If any damage is
found, consult your
Yamaha agency.
b. Cut the strap, and then remove the top
cover.
c. Remove all of the bolts from the bot-
tom plate, and then remove the frame.
Be careful not to damage the outboard mo-
tor.
d. Remove the wrapping, and then check
the outboard motor for concealed
damage. If any damage is found, con-
sult your Yamaha agency.
e. Remove the top cowling.
f. Install the lifting harness “1” to the en-
gine hanger “2”.
g. Apply tension to the lifting harness.
h. Lift up the outboard motor carefully
along with the bottom frame “1”.
Make sure that the lifting harnesses do not
damage any parts of the outboard motor.
i. Remove the skeg holder “1”.
j. Remove the bolts “1”.
k. Remove the steering retainer.
l. Install a hydraulic steering cylinder or
steering cable following the recom-
mendation of the manufacturer (re-
mote control model).
m. For the procedure of outboard motor
mounting on
boat, see “Rigging
Guide” (6YR-2819Y-**).
n. Remove the lifting harness, and then
install the top cowling.
1
2
1
1
1