Outline
10-3
*1. Cylinder head, cylinder block
*2. Cylinder head, cylinder block, fuel cooler, exhaust guide
Impeller/water pump
housing
Replacement
Power trim and tilt unit Inspection
Propeller/propeller
n
ut/cotter pin
Inspection or replace-
ment as necessary
PCV (Pressure Control
Va
lve)
Inspection or replace-
ment as necessary
Shift link/shift cable
Inspection, adjustment
or replace
ment as nec-
essary
Spark plug(s)
Inspection or replace-
ment as necessary
Spark plug caps/spark
plug
wires
Inspection or replace-
ment as necessary
Water from the cooling
w
ater pilot hole
Inspection
Throttle link/throttle
cab
le
Inspection, adjustment
or replace
ment as nec-
essary
Thermostat
Inspection or replace-
ment as necessary
Timing belt
Inspection or replace-
ment as necessary
Valve clearance
Inspection and adjust-
ment
Cooling water inlet Inspection
Main switch/stop switch
Inspection or replace-
ment as necessary
Wire harness connec-
tions/wire coupler con-
nections
Inspection or replace-
ment as necessary
(Yamaha) Meter/gauge Inspection
Fuel tank (Yamaha por-
table tank)
Inspection and cleaning
as n
ecessary
Item Actions
Initial
Every
20 hours
(3 months)
100 hours
(1 year)
300 hours
(3 years)
500 hours
(5 years)
To Next Page
