Electronic control system
2-10
27 Water in fuel filter
The shift position switch is on
an
d the water detection switch
is on.
The alert buzzer sounds.
28 Shift position switch
Cranking while in gear.
Cranking while the shift posi-
tion switch circuit is open-cir-
cuited.
ECM does not control.
29 Air pressure sensor
Open or short circuit in the air
pre
ssure sensor circuit.
Output voltage is less than 0.2
V or more th
an 4.5 V.
Control is performed based on
the TPS
.
High engine idle speed.
44
Engine shut-off
sw
itch
Cranking when the clip is
removed.
Fuel injection is cut.
56 Main power supply
Main relay is off and the out-
put voltage is more than the
speci
fied level.
ECM does not control.
57
Starter magnet power
supply
Starter relay is on and the out-
put voltage is less than the
speci
fied level.
Starter relay is off and the out-
put voltage is more than the
speci
fied level.
ECM does not control.
58
HP fuel pump PWR
supply
High-pressure fuel pump is on
an
d the output voltage is less
than the specified level.
High-pressure fuel pump is off
an
d the output voltage is more
than the specified level.
ECM does not control.
86 Immobilizer
Open or short circuit in the Y-
COP circuit.
Communication error contin-
ues for more than 3 seconds.
The engine starts, but the
eng
ine speed is limited to less
than 2600 r/min.
Trouble
code
Item
T
rouble conditions to be
detected
Control and operation
To Next Page
