Electrical component and wire harness routing
5-8
1. Lighting coil (stator assembly)
2. Vapor shut-off valve
3. Pulser coil
4. Thermo sensor
5. Lighting coil lead
6. Intake air pressure/temperature sensor
lead
7. ISC valve lead
8. Blowby hose
A. 25 mm (0.98 in) or less
B. Using the clamp, fasten the ignition coil
lead
at the protective tube of the lighting
coil lead over the clamp.
C. Tiller handle model
D. Remote control model
E. Align the marking position of the blowby
hose
with the positioning tape of the wire
harness, and then fasten the blowby
hose and wire harness using the clamp.
F. Route the intake air pressure/tempera-
ture sensor lead without any slack.
G. Fasten the ISC valve lead to the ISC
v
alve coupler using the plastic tie so that
the lead has no slack.
When doing so, it does not matter in
wh
ich direction the plastic tie is wound.
H. Using the clamp, fasten the blowby hose
at the
positioning tape of the intake air
pressure/temperature sensor lead.
I. Fasten the pulser coil lead to the base
magn
et boss using the clamp, and then
cut the end of clamp so that it is less than
1 mm (0.04 in).
J. Arrange the end of the plastic tie so that
it in
terferes with neither the mounting
boss of the flywheel magnet cover nor
the pulser coil lead.
Do not cut off the end of the plastic tie.
K. Install the clamp to the base magnet
boss as sho
wn, and then fasten the light-
ing coil lead using the clamp.
L. Arrange the intake air pressure/tempera-
ture sensor lead and ISC valve lead
inside t
he end surface of the blowby
hose.
To Next Page
