6MEMory Subsystem
154 U2000 Series Programming Guide
Query Example
Error Messages
• If more than 80 offsets for frequency dependent offset tables are in the list,
error –108, “Parameter not allowed” occurs.
• If a table is not specified using the MEMory:TABLe:SELect command, the
data cannot be entered and error –221, “Settings conflict” occurs.
• If any of the offset factors are outside of the allowed range, error –222,
“Data out of range” occurs.
MEM:TABL:GAIN? This command queries the offset in the
current table.
To Next Page
Loading...
