7SENSe Subsystem
167 U2000 Series Programming Guide
Syntax
Example
Reset Condition
On reset, automatic averaging is enabled.
For most applications, automatic filter length selection
(SENSe[1]:AVERage:COUNt:AUTO ON) is the best mode of operation. However,
manual filter length selection (SENSe[1]:AVERage:COUNt <numeric_value>) is
useful in applications requiring either high resolution or fast settling times, where signal
variations rather than measurement noise need filtering, or when approximate results are
needed quickly.
AVER:COUN:AUTO OFF This command disables automatic filter
length selection for power sensor.
To Next Page
Loading...
