7SENSe Subsystem
180 U2000 Series Programming Guide
Query Example
Error Messages
• If a duty cycle value is entered using
[SENSe[1]]:CORRection:DCYCle:GAIN3 while
[SENSe[1]]:CORRection:SPEed is set to 200, the error –221, “Settings
Conflict” occurs. However, the duty cycle value is set but the
[SENSe[1]]:CORRection:DCYCle:GAIN3:STATe command is nto
automatically set ON.
CORR:GAIN3? This command queries the current
setting of the duty cycle.
To Next Page
Loading...
