STATus Subsystem 9
U2000 Series Programming Guide 227
[:EVENt]?
This query returns a 16 bit decimal- weighted number representing the bits set
in the Event Register of the SCPI Register Set you require to control. The
format of the return is <NR1> in the range of 0 to 32767 (2
15
–1). This query
clears all bits in the register to 0.
Syntax
:ENABle <NRf>|<non-decimal numeric>
This command sets the Enable Register of the particular SCPI Register Set you
require to control. The parameter value, when rounded to an integer and
expressed in base 2 has its first 15 bits written into the Enable Register of the
SCPI Register Set concerned. The last bit (bit 15) is always set to 0.
Syntax
To Next Page
Loading...
