STATus Subsystem 9
U2000 Series Programming Guide 229
Syntax
Parameters
Query
:NTRansition?
The query returns a 15 bit decimal- weighted number representing the
contents of the Negative Transition Register of the SCPI register set being
queried. The format of the return is <NR1> in the range of 0 to 32767 (2
15
–1).
:PTRansition <NRf>|<non-decimal numeric>
This command is used to set the Positive Transition Register of the SCPI
Register Set you require to control. The first 15 bits of the input parameter are
written into the Positive Transition Register of the SCPI Register Set
concerned. The last bit (bit 15) is always set to 0.
Type Description Range of Values
NRf The value used to set the NTR
Register.
0 to 2
16
–1
non-decimal numeric
To Next Page
Loading...
Need help?
General
