EasyManua.ls Logo

Allen-Bradley SLC 500

Allen-Bradley SLC 500
269 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
QUICKDESIGNER ASCII Flex Protocol •
••
• 281
Explanation: (Compiler Error ) The length was not equal to 4.
Error #: 02:9B
Error Msg ERROR 02:9B No digit or . found for the Rx Float in a Receive command
Explanation: A Receive Command was being executed, it was expecting numeric data or a ‘.’ from the
controller but data was not numeric.
Error #: 02:9C
Error Msg ERROR 02:9C Invalid Command Read while processing an Unsolicited Sequence
Explanation: (Compiler Error ) A Command read while processing an Unsolicited Sequence was
invalid.
Error #: 02:9D
Error Msg ERROR 02:9D While processing an Unsolicited Command a match was not found
Explanation: An Unsolicited Command was received by the Quick Panel which did not have a match
in the table of Unsolicited Sequences.
Error #: 02:9E
Error Msg ERROR 02:9E Invalid Start of the Unsolicited Commands
Explanation: (Compiler Error )The first step of an Unsolicited Command was not a receive command.
Error #: 02:9F
Error Msg ERROR 02:9F Rcv Command failed on the 2nd Rcv of an Unsolicited Cmd
Explanation: A Unsolicited Sequence was being executed and the second Receive Command of the
Unsolicited Sequence failed.
Error #: 02:A0
Error Msg ERROR 02:A0 Rcv Buffer over flowed on the 2nd Rcv of an Unsolicited Cmd
Explanation: A Unsolicited Sequence was being executed and the second Receive Command of the
Unsolicited Sequence failed because the Receive Buffer over flowed. The End of Packet character
may be incorrect.
Error #: 02:A1
Error Msg ERROR 02:A1 Comm time-out on the 2nd Receive of an Unsolicited Cmd
Explanation: A Unsolicited Sequence was being executed and the second Receive Command of the
Unsolicited Sequence failed because the Communications Timed out wait for a packet.
Error #: 02:A2
Error Msg ERROR 02:A2 Could not release the RAM for the Poll Table
Explanation: Memory was dynamically allocated, and an attempt was made to free the RAM (probably
by going into a off-line mode) and it was unsuccessful.
Error #: 02:A3
Error Msg ERROR 02:A3 Ran out of RAM trying to allocate RAM for the Poll Table
Explanation: A problem occurred trying to dynamically allocate RAM for the Poll table.
Error #: 02:
Error Msg ERROR 02:A4 Error Allocating Memory for the Rx table
Explanation: A problem occurred trying to dynamically allocate RAM for the Rx table .

Table of Contents

Other manuals for Allen-Bradley SLC 500

Related product manuals