11..66 For SafetyFor Safety
This section contains warnings which should be followed to avoid personal
injury, product damage, as well as damage to the environment.
11..66..11 DangersDangers
DANGERDANGER
Replacing BatteryReplacing Battery When replacing the battery, use the specified battery and insert it with the
correct polarity. If the wrong battery is used, or if the battery is inserted with
reversed polarity, there is a risk of explosion causing severe injury or death.
FOR CALIFORNIA USA ONLYFOR CALIFORNIA USA ONLY
This product contains a CR Coin Lithium Battery which contains Perchlorate Material
- special handling may apply, see www.dtsc.ca.gov/hazardouswaste/perchlorate.
Battery DisposalBattery Disposal DO NOT expose batteries to heat or fire. This is dangerous and can result in
explosions or fire. Heating batteries may cause them to leak or explode.
11..66..22 WarningsWarnings
WARNINGWARNING
ALWAYS refer to the operation manual when working near locations at which
the alert mark shown on the left is attached. If the advice in the operation
manual is not followed, there is a risk of personal injury or reduced equipment
performance. The alert mark shown on the left may also be used with other
marks and descriptions to indicate other dangers.
Overvoltage Category
This equipment complies with overvoltage category II defined in IEC 61010.
DO NOT connect this equipment to the power supply of overvoltage category
III or IV.
Laser radiation warning
NEVER look directly into the cable connector on the equipment nor into the
end of a cable connected to the equipment. There is a risk of injury if laser
radiation enters the eye.
The Laser Safety label is attached to the equipment for safety use as indicated
in "Laser Safety".
RepairRepair Only qualified service personnel with a knowledge of electrical fire and shock
hazards should service this equipment. This equipment cannot be repaired by
the operator. DO NOT attempt to remove the equipment covers or unit covers
or to disassemble internal components. In addition, there is a risk of damage
to precision components.
To Next Page
Loading...
