Anritsu MT1000A - Fibre Channel

Port modePort mode
TopologyTopology
FramingFraming
ContentContent
Alarm InsertionAlarm Insertion
Error InsertionError Insertion
Link DetectionLink Detection
Login DetectionLogin Detection
Pattern DetectionPattern Detection
TransceiverTransceiver
BER TestBER Test
PerformancePerformance
Reflector modeReflector mode
Measurement Timing
Single, Repeat
1111..55..44 Fibre ChannelFibre Channel
Off, FC100, FC200, FC400, FC800, FC1200
Point to Point, Fabric, E-Port
SOF:Data:EOF, SOF:Header:Data:CRC:EOF
FOX, ALL5555, PRBS 9, PRBS 11, PRBS 15, PRBS 20, PRBS 23, PRBS 29,
PRBS 31, BHFTEST, BCRPAT, BJTPAT, BSPAT, USER_32, ZERO
Item
Link reset, Link reset response, Not optional, Offline
Item
Bit, Symbol, R_RDY, CRC
Insertion timing
Manual, Burst
Signal Present, Sync Acquired, Link Status
Fabric Login, Port Login, ELP
Traffic, Pattern Sync, Pattern Error
Module Present
Transceiver Information
Alarm, Wavelength and bit rate, Compliance, Vendor Information, Output
Control
Power monitor
BERT:
Pattern bit count, Pattern errors, Frame loss, Frame loss seconds, Pattern loss
seconds, Jitter, Latency, Service disruption
Symbol Errors
Ordered Sets:
R_RDY, LR, LRR, NOS, OLS
Traffic:
Frames, Bytes
Errors:
IFG, CRC, Symbol, CRD, Terminate, Errored
Line rate, Frame rate, Throughput
Size Distribution
Test Mode:
Port to Port, Loopback
Test:
Throughput, Traffic Profile, Latency, Burst, Credit (Only for Loopback mode)
Supports Reflector application.
1111..55..55 CPRI/OBSAICPRI/OBSAI
Measurement FunctionalityMeasurement Functionality
569569