Justification analysisJustification analysis
OH CaptureOH Capture
TransceiverTransceiver
APS MeasurementAPS Measurement
OTN PerformanceOTN Performance
MeasurementMeasurement
Tributary ScanTributary Scan
Round Trip DelayRound Trip Delay
Bit Error
Count
AMP
Positive(+1), Positive(+2), Negative (-1), offset(ppm)
GMP
CRC8 Error, CRC5 Error, Inc, Inc>1, Inc>2, Inc Over, Dec, Dec>1, Dec>2,
Dec Over, offset(ppm), Cm(t) Max, Cm(t) Min
OTU/ODU/OPU OH, Multiplexed ODU/OPU OH
TTI bytes, FTFL bytes with Multi-frame Manner
Update timing
Repeat 1sec, Single
Module Present
Transceiver Information
Alarm, Wavelength and bit rate, Compliance, Vendor Information, Output
Control
Power monitor
MDIO analysis
For CFP4:
NVR1, NVR2, Module FAWS, MW Lane FAWS, CTRL, MDIO Read/Write
I2C analysis
For QSFP+ and QSFP28:
Lower, Lower (Lane), Upper (00), Upper (03), Read/Write
Setting
VOD, Pre, Post, DFE, Insertion loss
Result : Average switching time, Maximum switching time, Minimum switching
time
Trigger
Start Trigger, Stop Trigger
Measurement Range
0.001 to 10.000 ms
Error Free Period
1, 10, 100, 200, 300, 400, 500, 600, 700, 800, 900 and 1000 ms
Standard
ITU-T Rec. G.8201, M.2401(M.2110)
Supports up to 10 Gbps.
Detected Alarms
OTU-AIS, LOF, OOF, LOM, OOM, SM-BIAE, SM-BDI, SM-IAE, ODU-AIS, ODU-
OCI, ODU-LCK, PM-BDI, LOFLOM
Result : RTD Time
Measurement Range
0.5sec, 1sec, 2sec, 5sec, 10sec
To Next Page
Loading...
