MiscellaneousMiscellaneous
ThroughputThroughput
Calculation LayerCalculation Layer
SelectionSelection
Throughput TypeThroughput Type
GraphicalGraphical
presentationpresentation
When this function is enabled, test results will be stored on the 'remote'
Network Master.
Include addresses in frame filter on receiverInclude addresses in frame filter on receiver
When enabling this function, the Ethernet frames which their destination
addresses match the following items will appear on the Streams screen.
Src MAC
Src IP
VLAN ID
Src Port
This setting has an effect on only the following measurement results on the
Statistics screen.
Multi Stream Transmit
Multi Stream Throughput
Multi Stream Frame Loss
Multi Stream Latencyt
Multi Stream Jitter
This setting does not have an effect on Frame Capture.
Measure jitter by means of latency testMeasure jitter by means of latency test
When selected the Latency Test will measure jitter instead of latency.
Accumulate repeated stepsAccumulate repeated steps
The RFC 2544 test (Throughput, Frame loss, Latency, and Burst) is performed
by steps by means of changing a parameter value. When selecting the check
box, the results of each steps are accumulated by each test when the tests are
repeated.
Select the layer on which the throughput calculation is done. As described in
the Throughput calculation section there are 6 different layers:
Utilization layer throughputUtilization layer throughput
Physical layer throughputPhysical layer throughput
Physical layer throughput (without preamble)Physical layer throughput (without preamble)
Link layer throughputLink layer throughput
Network layer throughputNetwork layer throughput
Data layer throughputData layer throughput
Data layer throughputData layer throughput appears when UDPUDP or TCPTCP is set to the layer 4 of the
Ethernet frame on 'Ports Setup' screen.
Select whether to register Average throughputAverage throughput or Maximum throughputMaximum throughput.
66..99..33 Test ResultsTest Results
The results of the performed RFC 2544 tests can be presented in either tabular
form or as graphical representations. The graphical presentation mode provides
an overview of the results and the progress of the test.
To Next Page
Loading...
