On the test-specific result screen, you switch between the two modes by using
the GraphGraph and TableTable buttons.
66..99..33..11 SummarySummary
When you go to the test results of the Ethernet RFC 2544 application, the
following screen is displayed.
This screen presents the current status of the test(s) (Configured / Not StartedConfigured / Not Started,
RunningRunning, CompletedCompleted or Not ConfiguredNot Configured). Touching the status button for a
specific test will display the result screen of the test.
66..99..33..22 ThroughputThroughput
Touching the ThroughputThroughput button in the navigation area will display the screen
shown below.
To Next Page
Loading...
