Selecting the DHCPDHCP check box located next to the Src IPSrc IP field will enable the
Dynamic Host Configuration Protocol function.
Selecting the DNSDNS check box located next to the Dst IPDst IP field changes the field
name to HostnameHostname, allowing you to specify the domain name server.
Touching the SetupSetup button next to the virtual Lamp in the Src IPSrc IP line will open
the DHCP/DNS SetupDHCP/DNS Setup dialog box.
Selecting the Renew lease when link is reestablishedRenew lease when link is reestablished check box enables the
function that automatically renews the lease when the link is reestablished.
Selecting the Get gateway servers through DHCPGet gateway servers through DHCP check box enables the
function that automatically assigns the gateway.
Selecting the Get DNS setup through DHCPGet DNS setup through DHCP check box enables the function
that automatically assigns the DNS server.
Primary DNSPrimary DNS and Secondary DNSSecondary DNS allow you to define these IPv4 addresses for
the specific stream.
When allocating IP addresses using DHCP, it is 'leased' for a certain period of
time defined by the network. The time when the lease expires is indicated as
Current lease expire time
.
Touching the Renew nowRenew now button will renew the allocation of the IP address.
Touching the CloseClose button closes the dialog box.
Gateway/Network maskGateway/Network mask
Select the GatewayGateway check box to enable the use of a gateway. When gateway is
enabled and the gateway/source address mask falls outside the network mask,
an ARP lookup for the gateway IP address will be made. The resulting MAC
address is used as destination. Gateway is usually used with ARP enabled as
well.
Touching the SetupSetup button next to the GatewayGateway check box will open the
Gateway SetupGateway Setup dialog box, in which you can set up the default gateway and/or
the network mask.
To Next Page
Loading...
