AudioCodes 420HD - Configuring a Line; Figure 17-4: Web Interface - Line Settings; Figure 17-5: Line Settings

400HD Series IP Phones
Administrator's Manual 102 Document #: LTRT-11950
17.3 Configuring a Line
This section shows how to configure a line.
Note: The Web interface page of the 440HD / 430HD phone are shown here. The Web
pages of the 420HD / 405 phones are identical, except:
• on the 420HD/405 phones, 'Line Mode' is not supported
• on the 420HD/405 phones, 'Label' is supported
• on the 420HD/405 phones, two lines can be configured; on the 430HD/440HD
phones, six lines can be configured.
 To configure a line using the Web interface:
1. Access the Line Settings page (Configuration > Voice Over IP > Line Settings):
Figure 17-4: Web Interface - Line Settings
2. Configure Line Mode using the table below as reference, and then click Submit.
 To configure line mode using the Configuration File:
• Use the table below as reference.
Figure 17-5: Line Settings
Parameter Description
Line Display Name
[voip/line/0/description]
Defines the SIP User ID which is sent in “INVITE” packets to the
called party in the “From” field, and should appear to the called
party as “Caller ID”. Default: 400HD
Line Activate
[voip/line/0/enabled]
Activates or deactivates the line. See also Section. 26.2.1.1.
[0] = Disabled (this is the default for the second line and higher
in the Configuration File)
[1] = Enabled (this is the default for the first line voip/line/0/ in
the Configuration File).
Line User ID
[voip/line/0/id]
Defines the SIP User ID provided by the SIP server which the
phone attempts to associate itself with during the registration
process. This is also the default ID sent in the “INVITE” if the
Line Display Name above is left blank.
Default: 0